EASY BUILD CASKET FOR YOUR HAUNTED HOUSE

Every good haunted house needs a good casket. Caskets are one of the most versatile halloween props you can have. They can be used for a good scare or as a piece of scenery. Today I want to show you a very easy design for a coffin that is effective as well as easy to build and will last for years. This coffin is constructed out of 1" by 12" pine boards. Unless you have a bunch of these lying around you will have to by them,
But that is the only wood you will need other than a piece of plywood for the bottom. You will also need some inch and a half wood screws, some small hinges, a piece or 2 of small rope or chain and some stain or paint. This project will require a power saw, a drill with a screw driver bit, wood glue and brushes or rags for your stain.
Now I am not going to post any dimensions because length and width will depend on what suits your own needs. This casket is based on the old toe hugger pine box caskets. I have included a rough drawing to give you an idea of what it looks like, hopefully I can add some better pictures soon. Now once you have your dimensions start by cutting out the two end pieces. Next You will need to cut the sides in two pieces, to make the angles in the sides. Once all of the pieces are cut, join them with wood glue then fasten them with wood screws. Now I use half inch plywood for my bottom. Simply lay the plywood on top of your frame and trace the outline. Now just cut out the bottom and fasten it to your frame with wood screws. Next you are ready to build your lid. I simply take two 1 by 12 pine boards and lay them on top of my frame side by side. Then like the bottom trace out your pattern and cut them out. Next take some of the scrap pine boards and cut out 2 brace for the lid(they are shown in the drawing). Now apply some wood glue to the bottom of your braces and fasten them to your lid with wood screw. I bout three small brass hinges at a hardware store and used them to mount my lid on my casket. Next I took a piece of nylon cord and stapled one end the the inside of my casket and the other end to the inside of my lid so that the lid would only open to a 90 degree angle. The last step is to apply paint or stain to your casket. I used a gel stain in a cherry color to give it an antiqued look. Since pine doesn't take stain very well without preparation it gives it a neat look. Now you have a very nice halloween prop that will last a long time and didn't cost a fortune. If you want to dress it up a little more you can go to a home improvement store and buy some handles for cabinet doors and mount around the sides, or some brass or stainless steel trim pieces. I hope this article inspires someone to build some nice halloween props.